MIL-DTL-28837/5B
Part or Identifying Number (PIN): M28837/5- (dash number from tables I and II).
REQUIREMENTS:
Design and construction:
Dimensions and construction: See figures 1 through 5.
Electrical characteristics:
Frequency range: See table I.
Input drive power: See table I.
Conversion loss (max): See table I.
Noise figure (SSB) (max): See table I.
Isolation: See table I.
Maximum power input (rms): See table I.
DC relative polarity: See table I.
VSWR: See table I.
Third order, two tone inter-modulation: See table I.
Impedance: 50 ohms.
Physical and environmental characteristics:
Weight: See table II.
Temperature: See table II.
Shock: See table II.
Seal: Non-hermetic: 4.8.8.2 of MIL-DTL-28837 applies.
Qualification: Not applicable (see note below).
NOTE: When there are no products listed or approved for listing on the qualified products list (QPL) for this
specification sheet, acquiring activities shall invoke first article inspection, consisting of meeting all qualification test
requirements of MIL-DTL-28837. Acquiring activities may require contractors to furnish first article samples of those
mixers that they propose to supply for Government inspection and contractual approval. First article approval is valid
only on the contract under which it is granted, unless extended by the Government to another contract. First article
inspection is performed by the contractor after award of contract and prior to production.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business